Northside Welding, Inc.
- Most American manufacturers of roll-over reset plows have stopped production in lieu of the less expensive “switch” plow. Unfortunately, for farmers burdened with rocky ground, this isn’t a practical solution.
- After years of replacing roll over stems, reinforcing three points, and adding additional bottoms, Northside Welding has now added a rollover reset plow to our manufacturing line. Without trying to reinvent the wheel, we have taken the stronger points of each manufacturer and combined them into one plow.
Standard Options:
- Main Frame is constructed with 8” x 6” x .375” tubing.
- Massive three point comes standard with category III and IV pins.
- Rollover Stem is a hefty 4 15/16” solid shaft, with 36” of bearing surface to roll on.
- Plow beams are cut from 1 ½” T-1 steel.
- Frogs are laser cut from 5/8” A-36 steel, resulting in a frog that is more shock resistant and won’t break at the point.
- Hydraulic Reset System uses a nitrogen accumulator for smooth and reliable reset action.
- The NSW plow uses readily available Case IH compatible consumables.
Models Available:
- 6 Bottom (on land)
- 7 Bottom (on land)
-
We can accommodate just about any size of tractor.
Our most common size, the 6 bottom on land, requires a minimum of 250 HP; however 280 HP is highly recommended for best results (depending on soil condition and plowing depth).
The 7 bottom plow requires a 310 HP.
